memewhe.blogg.se - Coleman saluspa error codes

Complete this for about, 2 to 3 minutes.

Using a hosepipe, flush water in through the pumps B pipe which should then come out the C.

Water flow sensors become stuck or flipped over.

Plug the spa back in and reset the pump.

This should move the sensor into the correct position.

Remove the pump from the spa liner by placing the stopper caps within the spa over the debris screens.

Move to the power supply, turn the power off and remove this from the socket.

Turn the pump off using the On/Off power button on the pump display.

Water flow sensors in the pump cause it to become noisy or overly loud. Your pump should now be working.Į04 Error Code Troubleshooting download E05

Press the thermal reset button for 10 seconds using a pencil or screwdriver (see Owner’s Manual for location).

Plug the pump unit back in and turn it back on.

Turn the pump unit off and unplug from the socket (leave for 10 seconds).

Press the test button once and leave it bleeping (leave for 10 seconds).

IMPORTANT: Before you restart the pump, press the reset button. Unplug the pump and plug it back in once the water temperature has reached 38✬ (100✯) or lower. The Lay-Z-Spa is not designed to operate with water temperatures exceeding 40✬ (104✯). The water temperature is over 50✬ (122✯). Allow time for the pump unit to cool down before connecting again. Place the stoppers caps inside the spa and disconnect the pump unit. Please contact us for more help with this If the above troubleshooting has not resolved the problem, the water flow sensors may not be working. If the washers are perished you can purchase spares from the Lay-Z-Spa website here We would suggest backwashing the pump to clear any debris. Check the condition of washers inside the couplings on the pump. You can manipulate these with warm water to return them to the correct shape.ĭisconnect the pump from the liner. Pipes within the liner are kinked or bent.ĭisconnect the pump and check the pipes inside the liner. If they are ok, continue to run the spa without the filter cartridge attached and see if the error code persists.Įnsure that the debris screens are clear of debris. These should lie flat inside the housing.

Remove the filter housing from the liner and check the black membrane inside.

Please make sure the new filter is clean and dry before you install it. Remove the filter cartridge from the filter housing and check it is clean. If you are unsure how to remove them, please refer to the assembly section within the Lay-Z-Spa owners manual. Remove the black stopper caps from the inside of the liner before heating, filtering or running the bubbles on the spa. The stopper caps are still inside the spa.